Elektron Digitone - Filter Parameters: Envelope and Type; Filter Envelope Settings (Attack, Decay, Sustain, Release); Filter Frequency, Resonance, and Type Selection

11. SYNTH TRACK PARAMETERS
43
Trig Trig
Reset on
Reset o
Trig Trig
Reset o (ARST/BRST OFF)
Trig Trig
Reset on
Reset o
Trig Trig
11.5.4 PHRT
Phase reset sets if the operators phase are reset to start at 0 or not when they are trigged.
OFF do not reset any operators
ALL resets all operators
C resets operator C
A+B resets operator A, B1, and B2
A+B2 resets operator A and B2
11.5.5 BDEL
Same as ADEL but for operator group B (B1 and B2).
11.5.6 BTRG
Same as ATRG but for operator group B (B1 and B2).
11.5.7 BRST
Same as ARST but for operator group B (B1 and B2).
11.6 FLTR PAGE 1
On FILTER page 1, you find all parameters that control the Multimode filter and its associated envelope.
Press [FLTR] once to access this parameter page.
11.6.1 ATK
Attack Time sets the length of the attack phase of the filter envelope. (0–127)
11.6.2 DEC
Decay Time sets the length of the decay phase of the filter envelope. (0–127)