6
DISCLAIMER
This document is the exclusive property of ELIWELL CONTROLS Srl and shall not be reproduced or distribuited
without authorisation of ELIWELL CONTROLS Srl.
Although great care has been exercised of this document, ELIWELL CONTROLS Srl, its employees or its vendors,
cannot accept any liability whatsoever connected with its use.
The same applies to any person or company involved in preparing and editing this document.
ELIWELL CONTROLS Srl reserves the right to make any changes or improvement without prior notice.
ELECTRICAL WIRING
Attention! Never work on electrical connections when the machine is switched on. The operation must be
carried out by qualified personnel.
To ensure proper connections, comply with the following:
using a power supply which does not correspond to the specifications given, can seriously damage the system;
use cables of suitable section for the terminals used.
Separate, as much as possible, the cables of probes and digital inputs from inductive loads and power
connections to prevent electromagnetic interference. Do not place the probe cables near other electrical
equipment (switches, meters, etc.)
Make connections as short as possible and do not wind them around electrically connected parts.
It is recommended to use screened wires for probe connections.
To avoid causing static discharges, do not touch the electronic components on the boards.
Eliwell supplies the high voltage cables to connect the device to loads, the power supply, probes, digital inputs, etc.
according to p/n - see the Accessories chapter.
The device must be connected to a suitable transformer that complies with the specifications provided in the
Technical Data chapter.
To Next Page
Loading...
Need help?
General
