Elna International Corps. SA 6004 Service manual
CIRCUIT BOARD C AND FUSE
To remove:
1. Remove the rear cover.
2. Remove three (3) set screws A and circuit board C (See page 20).
3. Remove three (3) set screws B and remove case cover D.
4. Replace fuse or circuit board C.
To fit:
5. Attach the case cover with three (3) set screws B.
6. Attach the circuit board C with three (3) set screws A.
7. Attach the rear cover.
NOTE: To replace the fuse, push the fuse out from fuse holder a with screwdriver as shown
below. Two specified fuses are used for circuit board C.
Fuse1 : 120 - 125V = 2,5 A
220 - 250V = 2,0 A
Fuse 2 : 120 - 125V = 3 A
220 - 250V = 5 A
Page 19
To Next Page
