ELNA CE10 - Adjusting X and y Sensors

26
Adjusting X and Y Sensors
To adjust X and Y sensors:
1Turn the Power “ON” to return the carriage to the
home position.
2Turn the Power “OFF” and then remove the base
unit.
3Loosen Screw A to adjust dimension Y to
moving the Y sensor attachinr plate .
4 Loosen screw B to adjust Dimension X-1 to
69.0 mm and Dimension X-2 to 2.25 mm by
moving the X shield plate .
5 Tighten Screw .
6. Attach the base.
1
2
3
4
5
7
6
1
2
3
4
5
6
7
4