ELNA CE10 - Replacing Switching Power Supply

29
Replacing Switching Power Supply
Replacement of Switching Power Supply
To remove:
1 Remove face cover, belt cover, front cover and rear
cover
2 Remove Screws (A) ,(B) and remove the
machine socket and fixing plate.
3Pull out the Machine socket unit connector .
4 Remove screw (C) and remove the Idler.
5 Remove Screws (D) (2 pieces) and Switching
power supply to the handwheel side.
To attach:
6Follow the above procedurte in reverse.
Screw (A)
Screw (B)
Screw (C)
Screw (D)
Idler
Machine socket unit connector (primary circuit)
Switching power supply unit
1
2
3
4
5
6
7
1
2
6
3
4
6
1
2
3
4
5
6
7