ELTEX MES53xx User Manual

MES53xx, MES33xx, MES23xx Ethernet Switch Series 118
ipv6 pim ssm {range
ipv6_multicast_subnet |
default}
-
Specify a multicast subnetwork
- range - specify a multicast subnetwork;
- ipv6_multicast_subnet - multicast subnetwork;
- default - specify a range in FF3E::/32.
no ipv6 pim ssm [range
ipv6_multicast_subnet |
default]
-
Disable this parameter.
ipv6 pim rp-embedded
-/enabled
Enable extended functions of a rendezvous point (RP).
no ipv6 pim rp-embedded
Disable extended functions of a rendezvous point (RP).
Ethernet interface configuration mode commands
Command line prompt is as follows:
console(config-if)#
Table 5.112. Ethernet interface configuration mode commands
Command
Value/Default value
Action
ip (ipv6) pim
-/enabled
Enable PIM on an interface.
no ip (ipv6) pim
Disable PIM on an interface.
ip (ipv6) pim bsr-border
-/disabled
Stop sending BSR messages from an interface.
no ip pim bsr-border
Disable this parameter.
ip (ipv6) pim dr-priority
priority
priority: (0..4294967294)/1
Specify the priority in selecting a DR router.
- priority - the priority to determine which switch will be a DR
router. The switch that has the highest value will be a DR
router.
no ip (ipv6) pim dr-priority
Return the default value.
ip ip (ipv6) pim
 secs
secs: (1..18000)/30 seconds
Specify a sending period for hello packets.
- sec - hello packet sending period.
no ip (ipv6) pim

Return the default value.
ip (ipv6) pim
interval
interval: (1..18000)/60
seconds
Specify a time period during which the switch will send join or
prune messages.
- interval - join or prune messages sending interval.
no ip (ipv6) pim

Return the default value.
ip (ipv6) pim
 acc_list
acc_list: (0..32) characters.
Filter incoming PIM messages.
- acc_list - the list of addresses to filter.
no ip (ipv6) pim

Disable this parameter.
EXEC mode commands
Command line prompt in the EXEC mode is as follows:
console#
Table 5.113. EXEC mode commands
Command
Value/Default value
Action
show ip (ipv6) pim rp mapping
[RP_addr]
-
Show active RPs linked to routing information.
- RP_addr – IP-address.
show ip (ipv6) pim neighbor
[detail]
[gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channel group|
vlan vlan_id]
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4);
group: (1..16);
vlan_id: (1..4094).
Show information about PIM neighbours.
show ip (ipv6) pim interface
[gigabitethernet gi_port |
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
Show information about PIM interfaces:
- state-on - displays all interfaces on which PIM is enabled;

ELTEX MES53xx Specifications

General

Brand	ELTEX
Model	MES53xx
Category	Switch
Language	English