ELTEX SBC-1000 - Page 141

SBC session border controllers 141
confirm
Confirm QoS settings. You have 1 minute to
confirm settings, or the previous values will be
restored.
exit
Return from this configuration submenu to the
upper level.
quit
Terminate this CLI session
save
Save QoS settings without applying
set
802.1p_prio_mapping
<PRIO>
<QUEUE>
0-7
0-3
Distribute packets into queues depending on the
802.1р priority.
PRIO — 802.1р priority number;
QUEUE — queue number
set
default_VLAN_priority
<PORT>
<DEFPRIO>
GE_PORT0(0)/
GE_PORT1(1)/
GE_PORT2(2)/
CPU(4)/
SFP0(6)/
SFP1(7)
0-7
Assign 802.1p priority to untagged packets
received on this port. If 802.1р or IP diffserv
priority is already assigned to the packet, this
setting will not be used ('default vlan priority'
will not be applied to packets containing IP
header, when one of the QoS modes is in use:
DSCP only, DSCP preferred, 802.1p preferred,
and also to untagged packets)
set
diffserv_prio_mapping
<NUMBER>
<QUEUE>
*1
0-3
Distribute packets into queues depending on the
IP diffserv priority.
NUMBER — IP diffserv priority number;
QUEUE — queue number
set egress_limit
<PORT>
<EGRLIM>
GE_PORT0(0)/
GE_PORT1(1)/
GE_PORT2(2)/
CPU(4)/
SFP0(6)/
SFP1(7)
on/off
Enable/disable bandwidth limit for outgoing
traffic from this port
set egress_rate_limit
<PORT>
<EGRRATE>
GE_PORT0(0)/
GE_PORT1(1)/
GE_PORT2(2)/
CPU(4)/
SFP0(6)/
SFP1(7)
0-250000
Set the bandwidth limit (kbit/s) for outgoing
traffic from this port
set
ingress_limit_mode
<PORT>
<INGRMODE>
GE_PORT0(0)/
GE_PORT1(1)/
GE_PORT2(2)/
CPU(4)/
SFP0(6)/
SFP1(7)
off/
all/
mult_flood_broad/
mult_broad/
broad
Set restriction mode for traffic coming to the
port
INGRMODE — restriction mode:
– off — no restriction;
– all — all traffic is restricted;
– mult_flood_broad — multicast,
broadcast, and flooded unicast traffic will
be restricted;
– mult_broad — multicast and broadcast
traffic will be restricted;
– broad — only broadcast traffic will be
restricted
set ingress_rate_
prio_0/1/2/3
<PORT>
GE_PORT0(0)/
GE_PORT1(1)/
GE_PORT2(2)/
CPU(4)/
SFP0(6)/
Set a bandwidth limit (kbps) for traffic arriving
on this port for zero/first/second/third queue.