ELTEX SBC-1000 - Page 142

142 SBC session border controllers
<INGPRIO>
SFP1(7)
0-250000
set QoS_mode
<PORT>
<QOSMODE>
GE_PORT0(0)/
GE_PORT1(1)/
GE_PORT2(2)/
CPU(4)/
SFP0(6)/
SFP1(7)
DSCP_only/
802.1p_only/
DSCP_preferred/
802.1p_preferred
Set QoS usage mode.
QOSMODE — usage mode:
– DSCP only — distribute packets into
queues based on IP diffserv priority only;
– 802.1p only — distribute packets into
queues based on 802.1p priority only;
– DSCP preferred — distribute packets into
queues based on IP diffserv and 802.1р
priorities, if both priorities are present in
the packet, IP diffserv priority is used for
queuing purposes;
– 802.1p preferred — distribute packets
into queues based on IP diffserv and
802.1р priorities, if both priorities are
present in the packet, 802.1p priority is
used for queuing purposes.
set
remapping_priority
<PORT>
<NUM>
<REMAP>
GE_PORT0(0)/
GE_PORT1(1)/
GE_PORT2(2)/
CPU(4)/
SFP0(6)/
SFP1(7)
0-7
0-7
Remap 802.1р priorities for tagged packets
PORT — configurable port;
NUM — current priority value;
REMAP — new value.
show QOS
<PORT>
GE_PORT0(0)/
GE_PORT1(1)/
GE_PORT2(2)/
CPU(4)/SFP0(6)/
SFP1(7)
Show QoS configuration parameters for the
given port
show QOS_diffserv
Show parameters for distribution of packets into
queues depending on the IP diffserv priority
show QOS_priomap
Show parameters for distribution of packets into
queues depending on the 802.1р priority
4.2.7.24 Syslog parameter configuration mode
To enter this mode, execute 'syslog' command in the configuration mode.
SBC-[CONFIG]> syslog
Entering syslog mode.
SBC-[CONFIG]-SYSLOG>
Command
Parameter
Value
Action
?
Show the list of available commands.
authlog set
IP
PORT
ONOFF
LOCREM
IP address in
AAA.BBB.CCC.DDD
format
1-65535
off/on
local/remote
Set the address of the server to send syslog
messages, as well as operation mode.
on/off — enable/disable logging;
local/remote — if set to remote, send logs to the
syslog server.
authlog show
Show current logging parameters
config
Return to Configuration menu.