EasyManua.ls Logo

ELTEX SBC-1000 - Page 143

ELTEX SBC-1000
211 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SBC session border controllers 143
dispatcher
DISPATCHER
0-99
Enable Dispatcher tracing
exit
Return from this configuration submenu to the upper
level.
manager
MANAGER
0-99
Enable Manager tracing
quit
Terminate this CLI session
show
Show information on Syslog configuration
start
Enable data transmission to the syslog server
stop
Disable data transmission to the syslog server
userlog
<IPADDR>
<PORT>
<MODE>
IP address in
AAA.BBB.CCC.DDD
format
1-65535
off/standart/full
Enable output of the history of entered commands
IPADDR syslog server IP address
PORT Syslog server port
MODE detail level of the entered commands log
off disable entered commands logs generation;
Standart messages contain the name of
modified parameter;
Full messages contain the name of modified
parameter as well as parameter values before and
after the modification.
worker
WORKER
0-99
Enable Worker tracing
4.2.7.25 SBC Trunk configuration mode
To enter this mode, execute 'trunk' command in the configuration mode.
SBC1000-[CONFIG]> trunk
Entering SBC trunk mode.
SBC1000-[CONFIG]-TRUNK>
Command
Parameter
Value
Action
?
Show the list of available commands.
add trunk
SBC_TRUNK_NAME
LOAD_BALANCE_MODE
LOAD_BALANCE_TIME
OUT
String, 63
characters max.
active-active/
active-backup
5-65535
Add new SBC Trunk
Trunk name
Balancing mode
Balancing timeout, sec
exit
Return from this configuration submenu to the
upper level.
quit
Terminate this CLI session
remove by id
destination
primary
SBC_TRUNK_ID
1-65535
Remove main destination from trunk by ID
remove by id
destination
secondary
SBC_TRUNK_ID
1-65535
Remove redundant destination from trunk by ID
remove by id
trunk
SBC_TRUNK_ID
1-65535
Remove SBC trunk by its ID
remove
destination
primary
SBC_TRUNK_ID
0-65534
Remove main destination from trunk by index
remove
destination
secondary
SBC_TRUNK_ID
0-65534
Remove redundant destination from trunk by index
remove trunk
SBC_TRUNK_ID
0-65534
Remove SBC trunk by its index
set by id
destination
primary
SBC_TRUNK_ID
SBC_SIP_DESTINATI
ON_ID
1-65535
1-65535
Assign main destination to trunk by ID

Table of Contents