108                             SMG digital gateway 
    If an object type is not defined, the host value is assumed. 
 
2.  dir—defines the direction towards the object. This may have the following values: 
 src (object is a source), 
 dst (object is a destination), 
 src or dst (source or destination), 
 src and dst (source and destination). 
  
If the dir qualifier is not defined, the src or dst value is assumed. 
To intercept traffic from the any artificial interface, the inbound and outbound qualifiers 
can be used. 
 
3.  proto—defines the protocol the packets should belong to. This qualifier may have the 
following values: 
 ether, fddi1, tr2, wlan3, ip, ip6, arp, rarp, decnet, tcp, and udp. 
 If a primitive does not contain a protocol qualifier, it is assumed that all protocols 
compatible with the object type comply with this filter. 
In addition to objects and qualifiers, primitives may contain arithmetic expressions and keywords: 
  gateway, 
  broadcast, 
  less, 
  greater. 
Complex  filters  may  contain  a  set  of  primitives  connected  with  logical  operators  and,  or,  and  not.  To 
reduce the expressions which define filters, lists of identical qualifiers may be omitted. 
Filter Examples 
dst foo—filters the packets which IPv4/v6 recipient address field contains address of the foo host. 
src net 128.3.0.0/16—filters all Ipv4/v6 packets sent from the specified network. 
ether  broadcast—ensures  filtering  of  all  Ethernet  broadcasting  frames.  The  ether  keyword  may  be 
omitted. 
ip6 multicast—filters packets with IPv6 group addresses. 
For detailed information on packet filtering, see specialised resources. 
 
  Launch—begins data collection. 
  Finish—finishes data collection. 
  Restart—restarts the utility and begins data collection again. 
The Files and Folders section in /tmp/log contains a list of files in the corresponding /tmp/log directory.  
To download it to a local PC, check the checkboxes located next to the required filenames and click the 
Download button. To delete the specified files from the directory, click Delete. 
PCM–dump Utility Settings 
РСМdump—a  utility  to  intercept  and  analyse  signal  traffic  via  E1  streams.  The  device  enables  PCM-
dumping  either  for  a  single  or  for  multiple  streams;  for  a  simultaneous  PCM-dumping  for  multiple  streams,