ELTEX SMG-4 - Access Categories Configuration Mode; E1 Stream Configuration Mode

130 SMG digital gateway
show_dirs
Show a path to the FTP server access
directory
signature
<CDR_SIGNATURE>
String, 63 characters
max.
Specify a discriminant that will
facilitate identification of the device
which created the record
unsuccess
<CDR_UNSUCC>
yes/no
Store / do not store unsuccessful calls
(not resulted in conversation) into
CDR files
upload archive
ftp/tftp
<ARCHIVE_NAME>
<FTP/TFTP_server>
String, 63 characters
max.
IP address
Send an archive to the FTP/TFTP
server
4.3.7 Access Categories Configuration Mode
To enter this mode, execute the access category command in the configuration mode.
SMG4-[CONFIG]> access category
Entering Access-Category mode.
SMG4-[CONFIG]-[ACCESS-CAT]>
Command
Parameter
Value
Action
?
Show the list of available commands
config
Return to the Configuration menu
exit
Return from this configuration submenu
to an upper level
quit
Terminate this CLI session
set access
<CAT_IDX>
<ACCESS_IDX>
<ACCESSIBLE>
0-63
0-63
enable/disable
Define mutual access permissions for
categories:
- CAT_IDX—index of the access category
being configured;
- ACCESS_IDX—the category the access is
configured to;
- ACCESSIBLE—category access status
(available, not available).
set name
<CAT_IDX>
<NAME>
0-63
Access category
name, 31 character
max. (letters,
numbers, "_")
Set Access-Category parameters:
- CAT_IDX—index of the access category
being configured;
- NAME—access category name.
show category
<CAT_IDX>
0-63
Show this access category configuration
show list
Show all access categories configuration
4.3.8 E1 Stream Configuration Mode
To enter this mode, execute the e1 <E1_INDEX> command in the configuration mode, where <E1_INDEX>
is the number of an Е1 stream.
SMG4-[CONFIG]> e1 0
Entering E1-stream mode.
SMG4-[CONFIG]- E1[0]>