ELTEX SMG-4 - SIP;SIP-T Interface Configuration Mode

160 SMG digital gateway
accordance with the requirements of
the Republic of Kazakhstan
config
Return to the Configuration menu
exit
Return from this configuration submenu
to an upper level
history
Show the history of entered commands
ignore_RURI
no/yes
Ignore / do not ignore address in R-URI.
Address information after the "@"
separator in Request-URI is ignored;
otherwise, the gateway checks if the
address information matches the device
IP address and host name, and if there
is no match, the call is rejected.
port
<PORT>
1-65535
A port to receive SIP protocol messages
quit
Terminate this CLI session
show
Show SIP general configuration
T1
<T1_TIMER>
0-255
Set T1 SIP timer
T2
<T2_TIMER>
0-255
Set T2 SIP timer
T4
<T4_TIMER>
0-255
Set T4 SIP timer
transport
<TRANSPORT>
UDP-only/
UDP-prefer/
TCP-prefer/
TCP-only
Define the transport layer protocol to be
used to send and receive SIP messages:
TCP-prefer—the messages are received
via UDP and TCP. Transmission via
TCP. If failed to establish a TCP
connection, the messages are sent
via UDP;
UDP-prefer—the messages are received
via UDP and TCP. The packets
smaller than 1,300 bytes are sent
via TCP, while the ones larger than
1,300 bytes—via UDP;
UDP-only—use the UDP protocol only;
TCP-only—use the TCP protocol only.
4.3.19 SIP/SIP-T Interface Configuration Mode
To enter this mode, execute the sip interface <SIPT_INDEX> command in the configuration mode, where
<SIPT_INDEX> is the number of SIP/SIP–T interface.
SMG4-[CONFIG]> sip interface 0
Entering SIPT-mode.
SMG4-[CONFIG]-SIP/SIPT-INTERFACE[0]>
Command
Parameter
Value
Action
?
Show the list of available commands
access category
<CAT_IDX>
0-31
Define an access category for the
line group
alarm indication
<on/off>
Enable fault indication for interface
unavailability
cci
<on/off>
on/off
Enable support of channel integrity
checks
cgpn replace
<YES_NO>
no/yes
Take CgPN from the
Username/Number parameter; when
disabled, use the CgPN number
received in the incoming call
clearchan override
<on/off>
on/off
Enable the clear channel override