100 SMG digital gateway
IP Probing—used for a single-time check of device network connection.
To send a ping request (the ICMP protocol is used), enter the host IP address or network name in
the IP Probing field and click the Ping button. The result of the command execution will be shown
at the bottom of the page. The result contains information on the number the of transmitted
packets, the number of responses to the packets, the percent of lost packets, and the time of
reception/transmission (minimum/average/maximum) in milliseconds.
Periodic ping—used for periodic check of device network connection.
Enable—when checked, sends ping requests to the addresses specified in the host list.
Period, minutes—time interval between requests in minutes.
Attempts count—the number of attempts to send a request to an address.
Status
Start—launches/restarts periodic ping.
Stop—forcedly stops periodic ping.
Information—click this button to view the /tmp/log/hosttest.log log file which contains data on
the last attempt of periodic ping request transmission.
IP addresses list—a list of IP addresses to send periodic ping requests to.
To add a new address to the list, select it in the entry field and click the Add button. To remove an address,
click the Remove button next to the required address.
4.1.13 RADIUS Configuration
4.1.13.1 RADIUS Servers
The device supports up to 8 authorisation servers and up to 8 accounting servers.
Server reply timeout—amount of time to wait for a server response.
To Next Page
Loading...
