ELTEX SMG-4 - General Device Configuration Mode

SMG digital gateway 125
the starting E1 channel in the group;
CHAN_COUNT the number of
channels in the group.
chan group unblock
<CHAN_INDEX_START>
<CHAN_COUNT>
1-31
2-31
Unblock a group of channels
CHAN_INDEX_START the number of
the starting E1 channel in the group;
CHAN_COUNT the number of
channels in the group.
chan rel
<CHAN_INDEX>
1-31
Terminate connection in the specified
channel
chan reset
<CHAN_INDEX>
1-31
Reset the specified channel
chan rlc
<CHAN_INDEX>
1-31
Confirm disconnection in the specified
channel
chan unblock
<CHAN_INDEX>
1-31
Unblock the specified channel
exit
Return from this configuration submenu
to an upper level
link clr outage
Clear the CPU local failure status for a
channel
link send LFU
Send the link forced uninhibit message to
a stream
link send LIN
Send the link inhibit message to a stream
link send LUN
Send the link uninhibit message to a
stream
link set congestion
Set the overload status for a stream
link set outage
Set the CPU local failure status for a
stream
link start
emergency
Initiate emergency stream startup
link start normal
Initiate normal stream startup
link stop
Stop a stream
quit
Terminate this CLI session
show info chan
Show information on channel status in a
stream
show info link
Show information on stream status
4.3.5 General Device Configuration Mode
To proceed to device parameter configuration/monitoring, execute the config command.
SMG4> config
Entering configuration mode.
SMG4-[CONFIG]>
Command
Parameter
Value
Action
?
Show the list of available
commands
access category
Enter the access categories
configuration mode
alarm set cpu
yes/no
The control system will be
alerted about a high load on
the CPU
alarm set ram
yes/no
The control system will be
alerted about running out of
free RAM