ELTEX SMG-4 - Page 124

124 SMG digital gateway
SMG4> management
Entering management mode.
SMG4-[MGMT]>
Command
Parameter
Value
Action
?
Show the list of available commands
exit
Move to a higher menu level
history
Show the history of entered
commands
nslookup
<HOST>
string
Request IP address
of the host with the specified name
HOST—the address to be requested
ping host
<HOST>
Send a PING request to the specified
host
ping ip
<IP>
IP address in the
AAA.BBB.CCC.DDD
format
Send a PING request to the specified
IP address
e1 stat clear
<STREAM>
0-3
Reset statistics for the specified Е1
stream
e1 stat show
<STREAM>
0-3
Show statistics for the specified Е1
stream
e1 test remote_loop
<STREAM>
0-3
Set a remote loop on the specified
E1 stream
e1 test prbs
<STREAM>
0-3
Transmit a PRBS sequence to the
specified E1 stream
e1 test prbs_local_loop
<STREAM>
0-3
Set a local loop and transmit a PRBS
sequence to the specified E1 stream
e1 test off
<STREAM>
0-3
Disable a test/loop on the specified
E1 stream
ss7link
<SS7_LINK>
0-3
Proceed to management of
parameters of the specified E1
stream
quit
Terminate this CLI session
4.3.4.1 SS-7 Stream Management Mode
To enter this mode, execute the ss7link <Link> command in the SS-7 stream configuration mode, where
<Link> is an SS-7 stream number and may take values in the range of 0–15.
SMG4-[MGMT]> ss7link 0
E1[0]. Signaling is SS7
SMG4-[MGMT]-[SS7LINK][0]>
Command
Parameter
Value
Action
?
Show the list of available commands
chan block
<CHAN_INDEX>
1-31
Block the specified channel (BLO)
chan group block
<CHAN_INDEX_START>
<CHAN_COUNT>
1-31
2-31
Block a group of channels
CHAN_INDEX_START the number of
the starting E1 channel in the group;
CHAN_COUNT the number of
channels in the group.
chan group reset
<CHAN_INDEX_START>
<CHAN_COUNT>
1-31
2-31
Reset a channel group
CHAN_INDEX_START the number of