174 SMG digital gateway
6 APPENDIX B. ALTERNATIVE METHOD OF DEVICE FIRMWARE UPDATE
In case firmware update via web interface or console (Тelnet, RS-232) is not possible, an alternative
firmware update method via RS-232 can be used.
To update the device firmware, the following programs are required:
Terminal program (for example, TERATERM);
TFTP server program.
Firmware update procedure:
1. Connect to the Ethernet port of the device.
2. Connect the PC COM port to the device console port using a crossed cable.
3. Run the terminal program.
4. Configure data transmission rate: 115200, data format: 8 bit w/o parity, 1 stop bit, w/o flow
control.
5. Run the tftp server program on the PC and specify the path to the smg_files folder. Create the
smg4 subfolder in the folder and place there the smg4_kernel, smg4_initrd files (the computer that runs
the TFTP server and the device should be located in the same network).
6. Turn the device on and stop the startup sequence by entering the stop command in the terminal
program window:
BootROM 1.08
Booting from SPI flash
General initialization – Version: 1.0.0
High speed PHY – Version: 2.1.4 (COM-PHY-V20)
Update PEX Device ID 0x67100
High speed PHY – Ended Successfully
DDR3 Training Sequence – Ver 5.5.0
DDR3 Training Sequence – Run without PBS.
DDR3 Training Sequence – Ended Successfully
BootROM: Image checksum verification PASSED
__ __ _ _
| \/ | __ _ _ ____ _____| | |
| |\/| |/ _` | '__\ \ / / _ \ | |
| | | | (_| | | \ V / __/ | |
|_| |_|\__,_|_| \_/ \___|_|_|
_ _ ____ _
| | | | | __ ) ___ ___ | |_
| | | |___| _ \ / _ \ / _ \| __|
| |_| |___| |_) | (_) | (_) | |_
\___/ |____/ \___/ \___/ \__|
** LOADER **
U-Boot 2011.12 (Jul 22 2014 – 16:26:55) Marvell version: v2011.12 2013_Q3.1
Board: RD-88F6W11
SoC: MV6710 A1
CPU: Marvell PJ4B v7 UP (Rev 1) LE
To Next Page
Loading...
