ELTEX SMG-4 - Trunk Group and Trunk Direction Configuration Mode

170 SMG digital gateway
rtp-create
<RTP>
0-99
Enable tracing of RTP forwarding
creation with the specified debug level;
0—disable data transfer
show
Show Syslog configuration information
sipt
<SIPT>
0-99
Enable tracing of SIP-T signalling with
the specified debug level; 0—disable
data transfer
start
Enable data transmission to the syslog
server
stop
Disable data transmission to the syslog
server
userlog
<IPADDR>
<PORT>
<MODE>
IP address in the
AAA.BBB.CCC.DDD
format
1-65535
off/standart/full
Enable history registration for the
entered commands
IPADDR—IP address of the syslog
server;
PORT—port of the syslog server;
MODE—verbosity level of the entered
commands log;
off—disable generation of the
entered commands log;
standard—messages contain the
name of the modified parameter;
full—messages contain the name of
the modified parameter as well as
parameter values before and after
modification.
4.3.24 Trunk Group and Trunk Direction Configuration Mode
To enter the trunk group configuration mode, execute the trunk group <TRUNK_INDEX> command in the
configuration mode, where <TRUNK_INDEX> is a trunk group number.
SMG1016M-[CONFIG]> trunk group 0
Entering trunk-mode.
SMG1016M-[CONFIG]-TRUNK[0]>
Command
Parameter
Value
Action
?
Show the list of available
commands
channel add
<TimeSlot>
1-31
Add a channel into the trunk
group. It is used when
destination = E1-channels
channel order
<VALUE>
first_forward/ successive_forward
The order of channel
engagement in the trunk group
first_forward—from the first
and forward;
successive_forward—
sequential forward;
channel remove
<TimeSlot>
1-31
Remove a channel from the
trunk group. It is used when
destination = E1-channels
config
Return to the Configuration
menu