SMG digital gateway 21
2 SMG INSTALLATION
Check the device for visible mechanical damage before installing and turning it on. In case of any damage,
stop the installation, fill in the corresponding document, and contact your supplier.
If the device has been exposed to low temperatures for a long time before installation, leave it for 2 hours
at ambient temperature prior to operation. If the device has been exposed to high humidity for a long time,
leave it for at least 12 hours in normal conditions prior to turning it on.
2.1 Startup Procedure
1. Connect stream (E1) and Ethernet cables to corresponding gateway connectors.
2. Connect the power adaptor to the device.
3. Turn the device on and check the front panel LEDs to make sure the terminal is in normal
operating conditions.
2.2 Opening the Casing
Prior to proceed, disable SMG power supply and disconnect all cables.
Fig. 2.1—Opening the Casing
1. Use a screwdriver to remove 4 screws holding the bottom panel of the device as shown in the
figure.
2. Pull the top panel (cover) of the device to remove it.
To assemble the device, repeat all the steps above in the reverse order.
To Next Page
Loading...
