ELTEX SMG-4 - Tracing Commands Available through the Debug Port; SMG Configuration Via Telnet, SSH, or RS-232

116 SMG digital gateway
4.2.2 Tracing Commands Available Through the Debug Port
4.2.2.1 Enable Debugging Globally
Command syntax: trace start
4.2.2.2 Disable Debugging Globally
Command syntax: trace stop
4.2.2.3 Enable/Disable Debugging for Specific Arguments
Command syntax: trace <POINT> on/off <IDX> <LEVEL>
Parameters:
<POINT> argument;
<IDX> numeric parameter;
<LEVEL> debug level.
Acceptable arguments (<POINT>):
<POINT>
Value
Command Description
<IDX>
Value
hwpkt
Tracing of packet contents at the first level of exchange between the
main application and the E1 stream driver
0..3
stream
E1 stream tracing
0..3
port
Application operation tracing
Not used
isup
ISUP subsystem operation tracing in the SS-7 protocol
Not used
mtp3
MTP3 level operation tracing in the SS-7 protocol for an Е1 stream
0..3
sipt
SIP/-T/-I protocol operation tracing
Not used
pril3
DSS1 protocol third level operation tracing for an Е1 stream
0..3
sw
Switch network operation tracing
Not used
mspc
IP forwarding tracing
Not used
mspd
Signal processor operation tracing
0
net
Tracing of the 2
nd
layer data network operation
Not used
sync
Tracing of synchronisation sources operation
Not used
erl1
Low-level tracing of the system which transfers messages between the
application and the SIP module
Not used
erl3
High-level tracing of the system which transfers messages between the
application and the SIP module
Not used
snmp
SNMP protocol operation tracing
Not used
np
Numbering (routing) schedule operation tracing
Not used
mod
Modifier operation tracing
Not used
alarm
Gateway fault state tracing
Not used
radius
RADIUS protocol operation tracing
Not used
4.3 SMG Configuration via Telnet, SSH, or RS-232
To configure the device, connect to it via the Telnet or SSH protocol, or by the RS-232 cable (for access via
CLI). Factory settings for IP address: 192.168.1.2; mask: 255.255.255.0.
The device configuration is stored in text files located in the /et/config directory. The files can be edited
in the joe integrated text editor (the changes will take effect after device restart).