ELTEX SMG-4 - Page 115

SMG digital gateway 115
radshow
Show the list of requests to the RADIUS server
rstat
Show the RADIUS protocol operation statistics
msploopext
Set traffic loop on the VoIP submodule to test packets passing through it;
the packets are generated by an external device
msploopint
Set traffic loop on the VoIP submodule to test packets passing through it;
the packets are locally generated on SMG
msploopstop
Cancel traffic loop on the VoIP submodule
q931timers
Show Q.931 timer values
resolve
Check domain name resolution. Parameter: domain name
route
Show information on network routes processed by telephony
netiface
Information about network interface
showcall
Show information on currently active calls
licence
Show information on currently active licences
mspping [on/off]
<idx>
Enable/disable signal processor querying; idx—signal processor number—0
stream [stream]
Show the status of E1 streams or a specific stream, stream is the stream
number (0–3)
e1stat <stream>
Show E1 stream counters
e1chip
Version and type of the chip processing E1 streams
alarm
Show alarm log information
sync
Show information on synchronisation sources
syncfreq
Show information on synchronisation frequency
setsync
Forced synchronisation source change.
Parameter: <stream number>
checkmod
Check the number modifier operation for a specific number.
Parameters: <modifier table> <the phone number to be checked>
cic <linkset>
Show the status of channels in the line group, <linkset> is the number of SS-
7 line group
checknum
Check the number with the numbering schedule
cfg_read
Apply the current configuration; this command resets and re-initialises E1
streams
callref
Show information on active SIP calls
rtpdebug <level>
Enable switch RTP debugging; <level> is a debug level
WARNING! This command may cause the switch to become unresponsive
under load
mspcports
Show RTP port status
mspshow/mspcshow
Show signal processor connection statistics
mspreglog
Enable signal processor command tracing
mspunreglog
Disable signal processor command tracing
talk
Show call statistics
frmtrace
Enable low-level tracing for E1 signal streams. Parameters: <level> <stream
number> <usage>
– level: l1, l2, l3;
– usage: 1—enabled, 0—disabled.
sys
Show system information, firmware version
trace
Tracing functions
regcon
This command returns to normal operation after the unregcon command (if
the application has not terminated abnormally)
unregcon
This command is used in extreme cases to identify the accurate location of
the application abnormal termination
stop
Restart the firmware