ELTEX SMG-4 - Page 127

SMG digital gateway 127
configuration mode
history
Show the history of entered
commands
hostping
Enter the regular ping
configuration mode
linkset
<LINKSET_INDEX>
0-3
Enter the SS-7 line group
configuration mode
modifiers table
<MODTBL_INDEX>
0-255
Enter the modifier table
configuration mode
network
Enter the network
configuration mode
new linkset
Create a new SS-7 line group
new trunk
Create a new trunk group
new prefix
Create a new prefix
new sipt-interface
Create a new SIP-T interface
new radius-profile
Create a new RADIUS profile
new modifiers-table
Create a new modifier table
new sipcause-profile
Create a correspondence table
for q.850 and sip-replies
new routing-profile
Create a scheduled routing
table
new ss7timers
Create an SS-7 timer profile
numplan
Enter the numbering schedule
configuration mode
ports range
<RANGE_PORT>
1-65535
Define a range of UDP ports
used for voice traffic (RTP) and
data transmission via the T.38
protocol
ports show
Show UDP ports configuration
ports start
<START_PORT>
1024-65535
Define the starting UDP port
used for voice traffic (RTP) and
data transmission via the T.38
protocol
q931-timers
Enter the Q.931 timer
configuration mode
quit
Terminate this CLI session
radius
Enter the RADIUS
configuration mode
route
Enter the static route
configuration mode
routing
Enter the scheduled routing
configuration mode
show running main
by_step
Show the current main
configuration by steps
show running main
whole
Show the current main
configuration in full
show running network
Show the current network
configuration
show running
radius_servers
Show the current RADIUS
server configuration
show running snmp
Show the current SNMP
configuration
show startup main
by_step
Show the initial main
configuration by steps
show startup main
whole
Show the initial main
configuration in full
show startup network
Show the initial network
configuration