ELTEX SMG-4 - Page 133

SMG digital gateway 133
CORNET
HICOM-350
AVAYA-DISPLAY
none - name transmission is disabled;
Q931-DISPLAY – transmission in
Q.931 Display element with Codeset
5;
QSIG-NA – transmission via QSIG-NA
(ECMA-164) protocol;
CORNET – transmission via Siemens
CorNet protocol;
HICOM-350 – transmission via
Siemens CorNet protocol with
supplementary information for Hicom
PBX;
AVAYA-DISPLAY – transmission in
Q.931 Display element with Codeset
6;
numbering plan
<PLAN>
0-15
The numbering schedule to be used
for accepted calls routing
numplan
<CLD_PLAN_ID>
unknown/ISDN/
telephony/National/
Privat
Set a numbering schedule type To
use the E.164 common numbering
schedule, select ISDN/telephony
quit
Terminate this CLI session
RestartChannel
<SEND>
send/don't_send
Send / do not send channel RESTART
RestartInterface
<SEND>
send/don't_send
Send / do not send interface RESTART
RoutingProfile
<PROF_NUM>
0-127
Set a scheduled routing profile
SendCatAON
<ON_OFF>
on/off
Enable/disable Caller ID category
transmission as the first digit of a
number in the SETUP message
Proper operation requires support of
this mode by the opposite party
SendDialTone
<ON_OFF>
on/off
Send / do not send the DialTone
ready signal into the line during
incoming overlap engagement
SendEndOfDial
<ON_OFF>
on/off
Enable/disable the "End of dial"
message transmission
show
Show Q.931 signalling configuration
trunk
<trunk_index>
0-31
Define the trunk group number for
this stream
4.3.8.3 SS-7 Signalling Configuration Mode for the Current E1 Stream
This mode is available only for SS7 signalling (set by the signaling command). To enter this mode, execute
the ss7 command in the E1 stream configuration mode.
SMG4-[CONFIG]-E1[0]> ss7
E1[0]. Signaling is SS7
SMG4-[CONFIG]-E1[0]-[SS7]>
Command
Parameter
Value
Action
?
Show the list of available commands
CIC fill
<CIC>
<step>
0-65535
0-255
Set a CIC value for all time slots
beginning from 0
CIC—CIC starting number;
step—step number.
CIC set
<TIMESLOT>
<CIC>
0-31
0-65535
Set a CIC value for a single timeslot
TIMESLOT—timeslot number;