ELTEX SMG-4 - Page 155

SMG digital gateway 155
quit
Terminate this CLI session
retries
<RETRIES>
0-255
Set the number of request
transmission attempts
show config
Show information on RADIUS server
configuration
timeout
<TIMEOUT>
0-255
Set the amount of time to wait for a
server response (х100 ms)
4.3.16.1 RADIUS Profile Configuration Mode
To enter this mode, execute the profile <PROFILE_INDEX> command in the RADIUS configuration mode,
where <PROFILE_INDEX> is a RADIUS profile number.
SMG4-[CONFIG]-RADIUS> profile 0
Entering RADIUS-Profile-mode.
SMG4-[CONFIG]-RADIUS-PROFILE[0]>
Command
Parameter
Value
Action
?
Show the list of available
commands
acct answer
<ON/OFF>
off/on
Enable/disable acct message
transmission for call-orig =
answer
acct CdPN
<CDPN_MODE>
CdPN-IN/CdPN-OUT
Set a callee number for
Accounting-Request packets:
CdPN-IN—use the callee
number prior to
modification (the
number received in the
SETUP/INVITE packet);
CdPN-OUT—use the callee
number after
modification.
acct CgPN
<CGPN_MODE>
CgPN-IN/CgPN-OUT
Set a caller number for
Accounting-Request packets:
CdPN-IN—use the caller
number prior to
modification (the
number received in the
SETUP/INVITE packet);
CdPN-OUT—use the caller
number after modification.
acct name
<USERNAME_MODE>
cgpn/
ip_or_stream/
trunk
Define the User-Name
attribute for
Accounting-Request
packets:
cgpn—use the calling party
phone number as the
value;
ip_or_stream—use the calling
party IP address or
incoming connection
stream number as the
value;