EasyManua.ls Logo

ELTEX SMG-4 - Page 183

ELTEX SMG-4
198 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SMG digital gateway 183
Redirect (302): disabled
REFER: disabled
Session Expires: 1800
Min SE: 90
Refresher: uac
Rport: disabled
Options: disabled:0
FAX-detect: no detecting
FAX-mode: none
VBD: disabled
Jitter buffer adaptive mode
minimum size: 0 ms
initial size: 0 ms
maximum size: 200 ms
deletion mode: soft
deletion threshold: 500 ms
adaptation period: 10000 ms
adjustment mode: non-immediate
size for VBD: 0
SMG4-[CONFIG]-SIPT-INTERFACE[0]> exit // Exit the SIP-T interface configuration mode
Leaving SIPT mode
Routing Configuration (the above session continued)
SMG4-[CONFIG]> new trunk // Create a trunk group for the SS-7 line group
NEW 'TRUNK GROUP' [00]: successfully created
SMG4-[CONFIG]> new trunk // Create a trunk group to work via the SIP-T interface
NEW 'TRUNK GROUP' [01]: successfully created
SMG4-[CONFIG]> numplan // Switch to the numbering schedule configuration mode
NEW 'PREFIX' [00]: successfully created
SMG4-[CONFIG]-[NUMPLAN]> create prefix 0 // Create a prefix to transit in the SS-7 direction in numbering schedule 0
NEW 'PREFIX' [00]: successfully created
SMG4-[CONFIG]-[NUMPLAN]> create prefix 0 // Create a prefix to transit in the SIP-T direction in numbering schedule 0
NEW 'PREFIX' [01]: successfully created
SMG4-[CONFIG]-[NUMPLAN]> exit // Exit the numbering schedule configuration mode
SMG4-[CONFIG]> trunk group 0 // Switch to the trunk group configuration mode for the SS-7 line group
Entering trunk-mode
SMG4-[CONFIG]-TRUNK[0]> destination SS7 0// Associate trunk group 0 with SS line group 0
Trunk[0]. Set destination '2'
'TRUNK GROUP' [00]:
name: TrunkGroup00
disable out: no
disable in: no
reserv trunk: none
direct_pfx: none
RADIUS-profile: none
destination: Linkset [0]
Modifiers:
incoming calling: none
incoming called: none
outgoing calling: 0
outgoing called: 0
outgoing redirecting:none
outgoing orig-called:none
outgoing generic num:none
use in-band message: no
connected-num transit: normal

Table of Contents

Related product manuals