ELTEX SMG-4 - Page 55

SMG digital gateway 55
 New numbering schedule—the numbering schedule the call, which is routed by this prefix, will be
directed to.
 New access category—the access category to be allocated to the caller when the numbering
schedule is changed.
 Priority—sets the prefix priority within the range from 0 to 100. A prefix with a smaller value has a
higher priority (0 is the highest priority, 100 is the lowest).
CdPN settings
 Number type—the callee number type: unknown, subscriber number, national number,
international number, no change. The selected number type will be sent in SS-7, ISDN PRI, SIP-I/T
signalling messages during an outgoing call by a prefix ("no change" means that the number type
will not be converted, i. e. it will be sent in the form it has been received from the incoming
channel).
 Numbering plan type—the callee's numbering schedule type; may take the following values:
unknown, isdn/telephony, national, privat, no change. The selected numbering schedule type will
be sent in ISDN PRI signalling messages during outgoing call by a prefix ("no change" means that
the number type will not be converted, i. e. it will be sent in the form it has been received from
the incoming channel).
Direct route timers (used when trunk groups are directly connected without prefix mask analysis—the
Direct Prefix function in trunk group settings).
These timers work only when dialling in the overlap mode:
 Short timer—time interval in seconds when the digital
gateway will wait for further dialling if a part of address
information has already been received. The default value:
5 seconds.
 Duration—the timer for number dialling duration. The default value: 30 seconds.
The Mask List section allows configuration of number masks for routing
by this prefix.
To generate the list, use the following buttons:
— Add Mask;
— Edit Mask;
— Remove Mask;
— View Mask.
 Mask—a template or a set of templates, which is compared to
the caller or callee number received from the incoming channel.
It is used for further call routing (for mask syntax, see section
4.1.6.1).
 Type—mask type. Defines the number for the call routing—caller number (calling) or callee
number (called).
 Long timer—time interval in seconds when the digital gateway will wait for the next digit dialling
until a match to a sample from the numbering schedule is established. The default value:
10 seconds.
 Short timer—time interval in seconds when the digital gateway will wait for further dialling if the
dialled number already matches a sample in the numbering schedule, but additional digits may be
also dialled, which will result in a match to another sample. The default value: 5 seconds.