EMC Celerra

nas_storage
261
The nas Commands
cache_size = 32768
cache_slot_count = 860268
max_wr_pend_slots = 180000
max_da_wr_pend_slots = 90000
max_dev_wr_pend_slots = 6513
permacache_slot_count = 0
num_disks = 60
num_symdevs = 378
num_pdevs = 10
sddf_configuration = ENABLED
config_checksum = 0x01ca544
num_powerpath_devs = 0
config_crc = 0x07e0ba1e6
is_local = True
Physical Devices
/nas/dev/c0t0l15s2
/nas/dev/c0t0l15s3
/nas/dev/c0t0l15s4
/nas/dev/c0t0l15s6
/nas/dev/c0t0l15s7
/nas/dev/c0t0l15s8
/nas/dev/c16t0l15s2
/nas/dev/c16t0l15s3
/nas/dev/c16t0l15s4
/nas/dev/c16t0l15s8
Director Table
type num slot ident stat scsi vols ports p0_stat p1_stat p2_stat p3_stat
DA 1 1 DF-1A On NA 21 2 On On NA NA
DA 2 2 DF-2A On NA 8 2 On On NA NA
DA 15 15 DF-15A On NA 21 2 On On NA NA
DA 16 16 DF-16A On NA 8 2 On On NA NA
DA 17 1 DF-1B On NA 8 2 On On NA NA
DA 18 2 DF-2B On NA 21 2 On On NA NA
DA 31 15 DF-15B On NA 152 2 On On NA NA
DA 32 16 DF-16B On NA 165 2 On On NA NA
FA 33 1 FA-1C On NA 0 2 On On NA NA
FA 34 2 FA-2C On NA 0 2 On On NA NA
FA 47 15 FA-15C On NA 0 2 On On NA NA
FA 48 16 FA-16C On NA 0 2 On On NA NA
FA 49 1 FA-1D On NA 0 2 On On NA NA
Note: This is a partial listing due to the length of the output.
EXAMPLE #3 To rename a storage system, type:
$ nas_storage -rename APM00042000818 cx700_1
id = 1
serial_number = APM00042000818