server_date
337
The server Commands
Mover and the time server. Also provides information about the
current state of NTP service on the Data Mover.
timesvc
Displays the current time service configuration.
timezone
Displays the current time zone on the specified Data Mover.
[<timezonestr>]
Sets the current time zone on the specified Data Mover. The
<timezonestr> is a POSIX style time zone specification with the
following formats:
<std><offset> (no daylight savings time)
<std><offset><dst>[offset],start[/time],end[/time] (adjusts
for daylight savings time)
Note: See the Linux man page for tzset for information about the format.
SEE ALSO Configuring Celerra Time Services, server_dns, server_nis.
EXAMPLE #1 To display the current date and time on a Data Mover, type:
$ server_date server_2
server_2 : Thu Jan 6 16:55:09 EST 2005
EXAMPLE #2 To customize the display of the date and time on a Data Mover, type:
$ server_date server_2 "+%Y-%m-%d %H:%M:%S"
server_2 : 2005-01-06 16:55:58
EXAMPLE #3 To start time synchronization between a Data Mover and an external
source, type:
$ server_date server_2 timesvc start ntp -interval 06:00 172.24.102.20
server_2 : done
EXAMPLE #4 To set the time service without slewing the clock, type:
$ server_date server_2 timesvc set ntp
server_2 : done
EXAMPLE #5 To display statistical information, type:
$ server_date server_2 timesvc stats ntp
server_2 :
Time synchronization statistics since start:
hits= 2, misses= 0, first poll hit= 2, miss= 0
Last offset: 0 secs, 0 usecs
To Next Page
Loading...
