EMC Celerra

server_iscsi
379
The server Commands
Where:
EXAMPLE #14 To clear the LUN mask for the initiator,
iqn.1991-05.com.microsoft:winserver1.nasdocs.emc.com, type:
$ server_iscsi server_2 -mask -clear t1 -initiator
iqn.1991-05.com.microsoft:winserver1.nasdocs.emc.com
server_2 : done
EXAMPLE #15 To configure an iSNS client on the Data Mover for iSNS server with
IP address of 172.24.102.66, type:
$ server_iscsi server_2 -ns isns -set -server 172.24.102.66
server_2 : done
Note: Before modifying the -ns server or port, iSCSI service must be stopped,
then restarted once the changes are made. If the administrator fails to stop
the service, attempted modifications will have no effect until the service is
started even though the command reports "done".
EXAMPLE #16 To start the iSCSI service on the Data Mover, type:
$ server_iscsi server_2 -service -start
server_2 : done
EXAMPLE #17 To display the iSNS client service status, type:
$ server_iscsi server_2 -ns isns -info
server_2 :
iSNS Client Service Status
--------------------------
service : started
server : 172.24.102.66:3205[tcp]
state : SYNC
entity : isns:00000002
source : iqn.1992-05.com.emc:apm000438070430000-1
ESI support : TRUE
ESI port : 52427
ESI Time : 1131484090 (Tue Nov 8 21:08:10 2005)
timeout : 3000
trace : FALSE
PG support : TRUE
Where:
Value Definition
target alias name of the target.
initiator_name qualified name of the iSCSI initiator on the host.
grant LUNs number of the LUNs to which the initiator is granted access.
Value Definition
service whether the iSNS service is started or stopped.
server IP address of the iSNS server and port.