server_iscsi
381
The server Commands
EXAMPLE #19 To display statistics for the target, t1, and the current sessions on the
target, type:
$ server_iscsi server_2 -target -stat t1
server_2 :
Target Alias Name: t1
Target iSCSI Name:
iqn.1992-05.com.emc:apm000438070430000-1
[Login/Logout Stats]
Login Accepted: 1
Login Failed: 0
Redirect: 0
Authorize: 0
Authenticate: 0
Negotiate: 0
Other: 0
Logout Normal: 0
Logout Other: 0
Last Login Failed: N/A
[Session Stats]
Initiator:
iqn.1991-05.com.microsoft:winserver1.nasdocs.emc.com
TSIH: 1 ISID: 400001370000
Command PDUs: 5886
Read Command PDUs: 3604
Write Command PDUs: 2256
Response PDUs: 5886
Data-In PDUs: 1936
Data-Out PDUs: 0
R2Ts: 0
Tx Data Octets: 132134422
Rx Data Octets: 132573696
Digest Errors: 0
Connection Timeout Errors: 0
Where:
Value Definition
Target Alias Name alias for the iSCSI target’s qualified name.
Target iSCSI Name iSCSI qualified name of the target.
Login Accepts number of accepted login requests.
Login Failed number of rejected login requests.
Redirect number of logins that are redirected.
Authorize number of logins that failed due to authorization failure.
Authenticate number of login failures due to failed authentication.
Negotiate number of login failures due to errors in iSCSI parameter negotiation.
Other number of login failures due to other causes.
Logout Normal number of logouts requesting session closing.
Logout Other number of other logouts.
Initiator ID of initiator logged into target.
TSIH iSCSI session handle.
ISID iSCSI session ID.
Command PDUs number of SCSI command protocol data units (PDUs) received by target.
Read Command PDUs number of read command PDUs received by target.
To Next Page
Loading...
Need help?
General
