382
Celerra Network Server Command Reference Manual
The server Commands
EXAMPLE #20 To unbind the network portal 172.24.102.243:3260 on a target, t1,
type:
$ server_iscsi server_2 -target -unbind t1 np=172.24.102.243:3260
server_2 : done
EXAMPLE #21 To display the status of the iSCSI service, iSCSI session statistics and
statistics about login/logout attempts, type:
$ server_iscsi server_2 -service -status
server_2 :
**** ISCSI Service ****
Status: Running
Iscsi is configured to listen on ports:
TCP Port: 3260
Header Digests are preferred
Data Digests are not preferred
[Session Stats]
Session Failures: 0
Last Session Failed: N/A
[Login/Logout Stats]
Login Accepted: 0
Login Failed: 0
Redirect: 0
Authorize: 0
Authenticate: 0
Negotiate: 0
Other: 0
Logout Normal: 0
Logout Other: 0
Last Login Failed: N/A
Where:
Write Command PDUs number of write command PDUs received by target.
Response PDUs number of iSCSI response PDUs sent by target.
Data-In PDUs number of data-in PDUs.
Data-Out PDUs number of data-out PDUs.
R2Ts number of request to transfers issued during the session.
Tx Data Octets amount of transmitted data (in bytes).
Rx Data Octets amount of received data (in bytes).
Digest Errors number or errors in data and/or header digests.
Connection Timeout
Errors
number of errors caused by the connection between target and initiator timing out.
Value Definition
Status status of the iSCSI service on the Data Mover.
TCP Port listening port used by the iSCSI service.
Header Digests whether header digests are enabled or disabled.
Data Digests whether data digests are enabled or disabled.
Session Failures number of session failures.
Last Session Failed ID of the last failed session.
Login Accepts number of accepted login requests.
Login Failed number of rejected login requests.
To Next Page
Loading...
Need help?
General
