EMC Celerra User Manual

492
Celerra Network Server Command Reference Manual
The server Commands
-tape -info <tape_barcode | -all> -tlu <tlu_id>
Lists information on a particular tape, or on all tapes in a VTLU.
-tape -insert <tape_barcode> -tlu <tlu_id>
Moves a virtual tape from the vault to an import/export slot.
-tape -eject <tape_barcode> -tlu <tlu_id>
Ejects a tape from the import/export slot and places it in the vault.
-drive {-list <tlu_id>}
Lists the virtual tape drives associated with the specified VTLU.
-info <drive_id> -tlu <tlu_id> -id
Displays information on the specified tape drive.
-unmount <drive_id> -tlu <tlu_id>
Unmounts the tape from the drive and places it in its original
source slot. If the source slot is unavailable, the tape is placed in
another available slot.
SEE ALSO Configuring NDMP Backups to Disk on Celerra, and Celerra Network
Server Parameters Guide, nas_fs.
EXAMPLE #1 To set the chain_ID for server_2, type:
$ server_vtlu server_2 -service -set -chain 1
server_2 : done
EXAMPLE #2 To list the chain_ID for the VTLU service on server_2, type:
$ server_vtlu server_2 -service -info
server_2 :
starting chain id = 1
Where:
EXAMPLE #3 To create and configure a new VTLU on server_2, type:
$ server_vtlu server_2 -tlu -new -robot -vendor EMCCorp -product vtluRobot
-revision 1.1a -slots 256 -impexp 64 -drives 2 -drive -vendor EMCCorp -product
vtluDrive -revision 2.2a
server_2 :
id = 3
slots = 256
import/export slots = 64
robot vendor = EMCCorp
robot product = vtluRobot
Value Definition
starting chain id Starting chain of the VTLU device name. The device name format is c<x>t<y>l<z>, where <x> is the
starting chain. <y> and <z> are the target and LUN, respectively. The target and LUN values cannot be
modified.

EMC Celerra Specifications

General

Brand	EMC
Model	Celerra
Category	Server
Language	English