EMC VNX5300 Block

To Next Page

To Previous Page

VNX Block Configuration Worksheet

Table 10 IP address for each iSCSI NIC or HBA port (iSCSI initiator)

Server and Port Initiator IP Address Subnet Mask Default gateway

Main Page

Installation Guide1
Table of Contents3
Introduction5
Audience5
Shipment Methods5
- Overview of Installing an EMC Cabinet5
- Overview of Installing in a Customer Cabinet6
Prepare Your System7
Before You Begin7
- Site Requirements8
Unpack Your System9
Unpacking the Shipping Boxes9
Assemble Components in Your Cabinet11
Installing Rails11
- Installing the SPS Rails11
- Installing the DPE Rails12
Installing the Components13
- Installing the Standby Power Supply13
- Installing the Disk Processor Enclosure14
Cable Your System17
Cabling the Standby Power Supply to SP Serial Port17
Attach System to the Network18
- Attaching Storage Processors to the Network18
Power up21
Before You Power up21
Connecting or Verifying Power Cables21
Verifying System Status22
Add Additional Storage25
Disk-Array Enclosure Types25
Assembling Daes26
- Install DAE Rails27
- Install the DAE28
- Connect SAS DPE and DAE Cables30
Power up Daes32
Verify DAE Status33
Verify 3U, 15 3.5" Drive DAE Status33
Verify 2U, 25 2.5" Drive DAE Status34
Setup35
Connect a Management Station35
Initialize Your Storage System35
- Downloading the Unisphere Storage System Initialization Wizard35
Update the Storage System Software and Register Your System36
- Downloading USM Documentation36
- Downloading Unisphere Service Manager36
- Downloading the Latest Version of the VNX Operating Environment Software36
- Registering Your System for Service with Your Service Provider36
Check System Health37
Set the Storage System Cache Values37
Install ESRS and Configure Connecthome37
- Downloading ESRS Documentation38
- Downloading ESRS IP Client38
Configure Servers for VNX Systems38
Provision Storage38
Attach Bezels39
Planning Worksheets41
VNX Block Configuration Worksheet41
ESRS Worksheet44

EMC VNX5300 Block

Table of Contents

Related product manuals