6
EMC VNX5300 Block Installation Guide
Overview of installing in a customer cabinet
If your system was shipped to be installed in your own cabinet, the installation process involves
the following:
1. Read and complete the prerequisite tasks listed in “Before you begin”.
2. Unpack the shipping boxes and verify the shipping contents as described in “Unpack your
system” on page 9.
3. Remove shipping container contents and assemble the components in your cabinet as
described in “Assemble components in your cabinet” on page 11.
4. Cable your system as described in “Cable your system” on page 17.
5. Power up your system by connecting power cables, and then verify that the system powered
up correctly by checking the LEDs of the components as described in “Power up” on page 21.
6. Optionally, you can add a disk array enclosure (DAE), power it up and then verify that the DAE
was powered up correctly by checking the DAE LED status as described in “Add additional
storage” on page 25.
7. Complete the tasks listed in “Setup” on page 35.
To Next Page
Loading...
