Installation, Operation and Maintenance Manual
MAN-02-04-97-0713-EN Rev. 1
October 2019
5
Storage and Pre-Installation
Section 2: Storage and Pre-Installation
2.2.2 Short-term Storage (One Year or Fewer)
2.2.2.1 Indoor Storage
Make sure that the actuator is kept in a dry place, laid on a wooden pallet, and protected
from dust.
2.2.2.2 Outdoor Storage
• Make sure that the actuator is protected from the elements (e.g. protected from
rain by covering with a canvas tarp).
• Place the actuator on a wooden pallet or some other raised platform, such that it is
not in direct contact with the ground.
• If the actuator is supplied with standard plastic plugs, remove them from the
conduit entries and replace them with weather-proof plugs.
2.2.3 Long-term Storage (More Than One Year)
2.2.3.1 Indoor Storage
In addition to the instructions in Section 2.2.2.1:
• If the actuator is supplied with standard plastic plugs, replace them with
weather-proof plugs.
• If the actuator is provided with a lithium battery, remove it and store it in a clean
and dry location (see Section 11.3, Maintenance - Lithium battery change).
2.2.3.2 Outdoor Storage
In addition to the instructions in Section 2.2.2.2:
• Check the general condition of the actuator, paying particular attention to the
terminal board and local display glass.
• If the actuator is provided with a lithium battery, remove it and store it in a clean
and dry location (see Section 11.3, Maintenance - Lithium battery change).
Figure 2
To Next Page
Loading...
