Emerson Bettis XTE3000 - Set Maintenance Date

Installation, Operation and Maintenance Manual
MAN-02-04-97-0713-EN Rev. 1 October 2019
73
Section 9: Set-Up Routines
Set-Up Routines
9.3.6 Set Maintenance Date
The maintenance date routine allows the following operations:
• to set the last maintenance date
• to set the next maintenance date
• to set the start-up date
Configuration procedure
• Move the local selector to OFF and then simultaneously press OPEN and STOP.
Select the language and enter the password according to the instructions
(see “Entering the set-up mode”). When the message displayed is “SET-UP MODE
OK?” press YES. Press NO to scroll through the list of available menus and then YES
to select the "Maintenance" menu.
• Press NO to scroll through the list of available routines and press YES to select
"Maintenance Date".
• Press YES to set the last maintenance date. Press NO to skip to
“next maintenance date”.
Last maintenance date
• Press YES if the date is correct; otherwise, press NO to change it.
• Enter day, month, and year. Press NO to scroll through the list of available values;
press YES to select.
• Press YES if the date is correct.
Next maintenance date
• Press YES if the date is correct; otherwise, press NO to change it.
• Enter day, month, and year. Press NO to scroll through the list of available values;
press YES to select.
• Press YES if the date is correct.
Start-up date
• Press YES if the date is correct; otherwise, press NO to change it.
• Enter day, month, and year. Press NO to scroll through the list of available values;
press YES to select.
• Press YES if the date is correct.