Emerson Bettis XTE3000 User Manual

Installation, Operation and Maintenance Manual
MAN-02-04-97-0713-EN Rev. 1 October 2019
77
Section 10: View Routines
View Routines
10.2 Nameplate
Use this menu to view the data identifying the actuator. The data are entered in-house and
can only be changed by the manufacturer. The following data may be viewed:
• Serial number: max. 28 characters, unique identier of the actuator with reference
to the Emerson order acknowledgment.
• Actuator type: max. 28 characters, describes the type of actuator with reference to
the Emerson catalog.
• Torque / Thrust: nominal torque or thrust of actuator.
• Actuator speed: nominal speed of actuator.
• Speed Loop: parameters to set the speed loop (for XTE3000LP (Low Power) only)
• Power supply: nominal voltage and frequency of actuator.
• Motor data: includes the following data relevant to the electrical motor:
— Power type (3ph, 1ph, dc) - Power rating, max. 99.9 kW
— In, max. 99.9 A
— Is, max. 99.9 A/KT (for XTE LP)
— Icc, max 99.9 A/TMax (for XTE LP)
— Duty (S2/15 min, etc.)
— Poles (2, 4, etc.)
— Bettis name, max. 28 characters
— Gear ratio, max. 1000 /M.R. Ratio (for XTE LP)
• Test date: date of the in-house functional test of actuator.
• Wiring diagram (WD): wiring diagram number, max 28 characters.
• Enclosure: type of enclosure (Ex d, etc.), max. 28 characters.
• Certicate: number of certicate, max. 28 characters.
• Lubricant: type of lubricant, max. 28 characters.
• Revision: hardware revision of base card, software revision of H8 microprocessor,
software revision of PIC microprocessor.
• Torque sensor: data relevant to the relationship between motor torque and speed.
This set of data also includes the factory torque limit setting, “Torque set CL” and
“Torque set OP”.
View Procedure
• Move the local selector to OFF and then simultaneously press OPEN and STOP.
Select the language according to the instructions (see “Entering the view mode”).
When the message displayed is “VIEW MODE OK?” press YES. Press NO to scroll
through the list of available menus and press YES to select the "Nameplate" menu.
• Press YES to answer the prompt “view” or “next” and see the data in the above list.

Emerson Bettis XTE3000 Specifications

General

Brand	Emerson
Model	Bettis XTE3000
Category	Controller
Language	English