Emerson Bettis XTE3000 - Page 67

Installation, Operation and Maintenance Manual
MAN-02-04-97-0713-EN Rev. 1 October 2019
59
Section 9: Set-Up Routines
Set-Up Routines
Auxiliary output relays
For status indication or diagnostic purposes, 8 voltage-free contacts of 8 relays are available
to be congured individually to switch upon occurrence of the following conditions:
Status
• open limit
• closed limit
• position >= xx %
• position <= xx %
• closing
• opening
• motor running
• blinker
• mid-travel position
• local selected
• remote selected
• local stop active
• ESD signal on
• manual operation
• interlock PST-icon
• heater-only AS8
Alarm
• motor over-temperature
• over-torque
• over-torque in OP
• over-torque in CL
• valve jammed
• valve jammed in OP
• valve jammed in CL
• low lithium battery (if present)
• mid travel alarm in CL/OP
• mains-only AS8
Warning
• warnings
• PST failed (i.e. Partial Stroke Test failure)
The contacts may be congured to make or break on condition. The options “EFS in
manual”, “EFS mid-travel” and “PST failed” also appear in the menu, but are not available
on the XTE3000.