• All inductive coils must be suppressed with appropriate devices, such
as diodes or resistor/capacitor (RC) networks.
Mechanical Installation
Drive Mounting
Drives must be back mounted vertically on a metal surface
such as a NEMA enclosure. A minimum spacing of two inches
must be maintained above and below the drive for ventilation.
Side by side drive spacing requirements vary by drive size and
RMS loading. Additional space may be necessary for wiring
and cable connections.
For drive dimensions, weights and mounting specifications, see
the "Specifications" section.
Motor Mounting
Motors should be mounted firmly to a metal mounting surface
to ensure maximum heat transfer for maximum power output
and to provide a good ground.
For motor dimensions, weights and mounting specifications,
see the "Specifications" section.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
