Use tie wraps to provide a strain relief and a ground connection
at the shield connection points.
If you do not wish to use the DIN rail mounting hardware, the
ECI-44 can be disassembled and the mounting clips removed.
The ECI-44 wire range is #18 to 24 AWG stranded insulated
wire.
Note
Wiring should be done with consideration for future
troubleshooting and repair. All wiring should be either color
coded and/or tagged with industrial wire tabs. Low voltage
wiring should be routed away from high voltage wiring.
STI-EIO Interface
The STI-EIO interface allows access to all digital input and
output signals. The STI-EIO mounts directly to the J3
connector on the drive. See Figure 40 on page 70.
Note
Shield connection points are connected to the shell of the 44-
pin “D” connector on the STIEIO.
The STI-EIO wire range is #18 to 24 AWG stranded insulated
wire.
Note
Wiring should be done with consideration for future
troubleshooting and repair. All wiring should be either color
coded and/or tagged with industrial wire tabs. Low voltage
wiring should be routed away from high voltage wiring.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
