Emerson Epsilon Eb-202 - Input;Output and Drive Enable Wiring

34
Epsilon Eb Digital Servo Drive Installation Manual
Figure 17: Epsilon Brake Wiring Diagram using the I/O
Connector
Input/Output and Drive Enable Wiring
Drives are equipped with five optically isolated input lines (one
is dedicated to a drive enable function) and three optically
isolated output lines. They are designed to operate from a +10
to 30 VDC source. All inputs and outputs are configured as
sourcing. You are responsible for choosing a load that will limit
each output’s current to less than 150 mA.
Front View
19
10
8
Output #3
Drive Enable
I/O Common
I/O Supply
J3
-
+
K1
A
Internal
to Motor
C
B
Red +
Black -
Connected to
grounded
mounting panel.
Single point
PE ground.
11
A2
14
A1
2 Amp
Fuse
Customer
supplied drive
enable contact
Relay:
EMC #BRM-1
24 VDC
Motor
1 Amp
Fuse
CBMS-xxx Cable
20
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com