current loading must be limited to 150 mA per output
signal.
Command Connector Wiring
All command and digital I/O signals are available using the 44-
pin Command Connector.
If you are interfacing your drive(s) to an AXIMA 2000 or 4000
multi-axis controller, simply connect the 44-pin connector of
your AX-CEN-XXX cable to the drive and the 25-pin connector
to the AXIMA multi-axis controller.
If you are interfacing your drive(s) to an AXIMA or any other
motion controller, you may use either the CDRO-sss or CMDO-
xxx cables or the optional External Connection Interface (ECI-
44) which provides a convenient screw terminal connection
strip. Connect one end of the CMDX command cable to your
drive and the other end to the ECI-44.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
