4 Operation and Maintenance
4.1 Overview
This section contains information on operating and maintaining Rosemount
™
3051S
MultiVariable
™
Transmitters (Rosemount 3051SMV). Instructions for performing
configuration and calibration procedures are given for Field Communicator version 2.0 or
later, AMS Device Manager version 9.0 or later, and Engineering Assistant version 6.3 or
later. Screen shots for this section are taken from AMS Device Manager version 9.0;
Engineering Assistant screens will look similar and follow the same instructions for use and
navigation. For convenience, Field Communicator Fast Key sequences are labeled “Fast
Keys” for each software function below the appropriate headings.
Based on the configuration ordered, some measurements (i.e. static pressure, process
temperature) and/or calculation types (i.e. mass, volumetric, and energy flow) may not be
available for all fluid types. Available measurements and/or calculation types are
determined by the multivariable type and measurement type codes ordered. See Ordering
information for more information.
All screens in this section are shown for multivariable type M (fully compensated mass and
energy flow), measurement type 1 (differential pressure, static pressure, and process
temperature). Field Communicator Fast Keys are given for both multivariable type M and P
(direct process variable output) with measurement type 1. Field Communicator Fast Keys
and screens for other multivariable types and measurement types may vary.
4.2 Safety messages
Procedures and instructions in this section may require special precautions to ensure the
safety of the personnel performing the operation. Information that raises potential safety
issues is indicated with a warning symbol ( ). Refer to the following safety messages
before performing an operation preceded by this symbol.
Reference Manual Operation and Maintenance
00809-0100-4803 October 2018
Emerson.com/Rosemount 107
To Next Page
Loading...
