2.3 Engineering Assistant installation
2.3.1 Engineering Assistant version 6.3 or later
The Rosemount 3051SMV Engineering Assistant 6.3 or later is PC-based software that
performs configuration, maintenance, diagnostic functions, and serves as the primary
communication interface to the Rosemount 3051SMV with the fully compensated mass
and energy flow feature board.
The Rosemount 3051SMV Engineering Assistant software is required to complete the flow
configuration.
2.3.2 Installation and initial setup
The following are the minimum system requirements to install the Rosemount 3051SMV
Engineering Assistant software:
• Pentium-grade Processor: 500 MHz or faster
• Operating system: Windows
™
Professional 7, 8.1, 10
— 32-bit
— 64-bit
• 256 ΜΒ RΑΜ
• 100 ΜΒ free hard disk space
• RS232 serial port or USB port (for use with HART
®
modem)
• CD-ROM
Installing the Rosemount 3051SMV Engineering Assistant
version 6.3 or later
About this task
Engineering Assistant is available with or without the HART modem and connecting
cables. The complete Engineering Assistant package contains the software CD and one
HART modem with cables for connecting the computer to the Rosemount 3051SMV (See
Ordering information.)
Procedure
1. Uninstall any existing versions of Engineering Assistant 6 currently installed on the
PC.
2. Insert the new Engineering Assistant disk into the CD-ROM.
3. Windows should detect the presence of a CD and start the installation program.
Follow the on-screen prompts to finish the installation. If Windows does not detect
the CD, use Windows Explorer or My Computer to view the contents of the CD-
ROM, and then double select the SETUP.EXE program.
4. A series of screens (Installation Wizard) will appear and assist in the installation
process. Follow the on-screen prompts. It is recommended the default installation
settings are used.
Configuration Reference Manual
October 2018 00809-0100-4803
10 Rosemount 3051S Multivariable Transmitter
To Next Page
Loading...
Need help?
General
