defined atmospheric pressure. For more information on configuring the atmospheric
pressure, see Static pressure. Since only one of the static pressures is actually being
measured, there is a single damping setting for both variables which may be edited under
the Static Pressure heading.
• Under the Process Temperature heading, the Units and Damping for the Process
Temperature may be edited.
• Under the Module Temperature heading, the Units for the sensor module temperature
may be set. The sensor module temperature measurement is taken within the module,
near the differential pressure and/or static pressure sensors and can be used to control
heat tracing or diagnose device overheating.
• Under the Analog Output heading, the primary variable can be selected from the drop
down menu and the upper and lower range values (4 and 20 mA points) for the primary
variable may be edited.
• Under the Totalizer heading (fully compensated mass and energy flow feature board
only), the Totalizer can be configured by selecting the Configure Totalizer button. This
button allows the user to select the variable to be totalized. The Totalizer Units may
also be edited under this heading.
2.6 Detailed device configuration
2.6.1 Model identification
Mass and energy flow Fast Keys 1, 3, 5
Direct process variable output Fast Keys 1, 3, 5
The Identification tab displays the device identification information on one screen. The
fields with white backgrounds may be edited by the user.
Figure 2-19: Device - Identification Tab
Configuration Reference Manual
October 2018 00809-0100-4803
34 Rosemount 3051S Multivariable Transmitter
To Next Page
Loading...
