Based on the configuration ordered, some measurements (i.e. static pressure, process
temperature) and/or calculation types (i.e. mass, volumetric, and energy flow) may not be
available for all fluid types. Available measurements and/or calculation types are
determined by the multivariable type and measurement type codes ordered. See Ordering
information for more information.
All screens in this section are shown for multivariable type M (fully compensated mass and
energy flow) with measurement type 1 (differential pressure, static pressure, and process
temperature). Field Communicator Fast Keys are given for both multivariable type M and P
(direct process variable output) with measurement type 1. Field Communicator Fast Keys
and screens for other multivariable types and measurement types may vary.
Note
All screen shots in this section will be shown using AMS Device Manager. Engineering
Assistant screens are similar and the instructions shown here apply to both AMS Device
Manager and Engineering Assistant.
When using Engineering Assistant, a Reset Page button will be shown. In online mode, the
Reset Page button will return all values on tab to the initial values received from the device
before the start of the configuration. If editing a previously saved configuration, the Reset
Page button will return all values on tab to those that were last saved. If starting a new
configuration, all entered values on tab will be erased.
CAUTION
When information is edited on any AMS Device Manager tab, it will be highlighted in
yellow. Edited information is not sent to the transmitter until the Apply or OK button is
selected.
Configuration Reference Manual
October 2018 00809-0100-4803
32 Rosemount 3051S Multivariable Transmitter
To Next Page
Loading...
