3.5.1 Install Rosemount
™
305 Integral Manifold
To install a Rosemount 305 Integral Manifold to a Rosemount 3051 Transmitter:
Procedure
1. Inspect the PTFE sensor module O-rings.
You may reuse undamaged O-rings. If the O-rings are damaged (if they have nicks
or cuts, for example), replace with O-rings designed for Rosemount transmitters.
Important
If replacing the O-rings, take care not to scratch or deface the O-ring grooves or the
surface of the isolating diaphragm while you remove the damaged O-rings.
2. Install the Integral Manifold on the sensor module. Use the four 2.25-in. manifold
bolts for alignment. Finger tighten the bolts; then tighten the bolts incrementally in
a cross pattern as seen in Figure 3-16 to final torque value.
See Flange bolts for complete bolt installation information and torque values. When
fully tightened, the bolts should extend through the top of the sensor
module housing.
Installation
Reference Manual
October 2018 00809-0100-4803
92 Rosemount 3051S Multivariable Transmitter
To Next Page
Loading...
