135
Reference Manual
00809-0100-4021, Rev GC
Section 3: HART commissioning
April 2014
HART® commissioning
Exceed field width Indicates that the field width for the current arithmetic variable exceeds the
device-specified description edit format.
Exceed precision Indicates that the precision for the current arithmetic variable exceeds the
device-specified description edit format.
Ignore next 50 occurrences of status? Asked after displaying device status. Softkey answer determines whether next 50
occurrences of device status will be ignored or displayed.
Illegal character An invalid character for the variable type was entered.
Illegal date The day portion of the date is invalid.
Illegal month The month portion of the date is invalid.
Illegal year The year portion of the date is invalid.
Incomplete exponent The exponent of a scientific notation floating point variable is incomplete.
Incomplete field The value entered is not complete for the variable type.
Looking for a device Polling for multidropped devices at addresses 1–15.
Mark as read only variable on hotkey
menu?
Asks whether the user should be allowed to edit the variable from the hotkey menu
if the item being added to the hotkey menu is a variable.
No device configuration in
configuration memory
There is no configuration saved in memory available to re-configure off-line or
transfer to a device.
No device found Poll of address zero fails to find a device, or poll of all addresses fails to find a device if
auto-poll is enabled.
No hotkey menu available for this
device.
There is no menu named “hotkey” defined in the device description for this device.
No offline devices available There are no device descriptions available to be used to configure a device offline.
No simulation
devices available
There are no device descriptions available to simulate a device.
No UPLOAD_VARIABLES in ddl for this
device
There is no menu named “upload_variables” defined in the device description for
this device. This menu is required for offline configuration.
No valid items The selected menu or edit display contains no valid items.
OFF KEY DISABLED Appears when the user attempts to turn the Field Communicator off before sending
modified data or before completing a method.
Online device disconnected with
unsent data. RETRY or OK to lose
data.
There is unsent data for a previously connected device. Press RETRY to send data, or
press OK to disconnect and lose unsent data.
Out of memory for hotkey
configuration. Delete unnecessary
items.
There is no more memory available to store additional hotkey items. Unnecessary
items should be deleted to make space available.
Overwrite existing configuration
memory
Requests permission to overwrite existing configuration either by a
device-to-memory transfer or by an offline configuration. User answers using the
softkeys.
Press OK Press the OK softkey. This message usually appears after an error message from the
application or as a result of HART communications.
Restore device value? The edited value that was sent to a device was not properly implemented. Restoring
the device value returns the variable to its original value.
Table 3-3. Field Communicator Error Warning Descriptions – HART
(1)
Message Description
To Next Page
Loading...
