212
Reference Manual
00809-0100-4021, Rev GC
Appendix A: Reference Data
April 2014
Reference data
Standard configuration
Both standard and custom configuration settings may be changed. Unless specified, the
transmitter will be shipped as follows:
Standard configuration
Description
4 mA value / Lower Range (HART / 4–20 mA) 0 °C
20 mA value / Upper Range (HART / 4–20 mA) 100 °C
Damping 5 seconds
Output Linear with temperature / FOUNDATION fieldbus
Failure Mode (HART / 4–20 mA) High
Line Voltage Filter 60 Hz
Software Tag If a Hardware Tag is specified it will be entered into
the software tag as well. Otherwise it will be left
blank.
Optional Integral Meter Units and mA / Sensor 1 units
Single sensor option
Description
Sensor Type 4-wire Pt 100 = 0.00385 RTD
Primary Variable (HART / 4–20 mA) Sensor 1
Secondary Variable Terminal (Body) Temperature
Tertiary Variable Not Available
Quaternary Variable Not Available
Dual sensor option Description
Sensor Type Two 3-wire Pt 100 = 0.00385 RTD
Primary Variable (HART / 4–20 mA) Sensor 1
Secondary Variable Sensor 2
Tertiary Variable Terminal Temperature
Quaternary Variable Not Used
To Next Page
Loading...
