40
Reference Manual
00809-0100-4021, Rev GC
Section 3: HART commissioning
April 2014
HART® commissioning
3.5 Review configuration data
Before operating the 3144P in an actual installation, review all of the factory-set configuration
data to ensure that it reflects the current application.
3.5.1 Review
Field communicator
Review the transmitter configuration parameters set at the factory to ensure accuracy and
compatibility with the particular application. After activating the Review function, scroll through
the data list and check each variable. If changes to the transmitter configuration data are
necessary, refer to “Configuration” below.
3.6 Check output
Before performing other transmitter online operations, review the configuration of the 3144P
digital output parameters to ensure that the transmitter is operating properly.
3.6.1 Analog output
Field communicator
The 3144P process variables provide the transmitter output. The PROCESS VARIABLE menu
displays the process variables, including sensed temperature, percent range, and analog output.
These process variables are continuously updated. The primary variable is 4–20 mA analog
signal.
3.7 Configuration
The 3144P must have certain basic variables configured to operate. In many cases, these
variables are pre-configured at the factory. Configuration may be required if the configuration
variables need revision.
HART 5 Fast Keys
1, 4
HART 7 Fast keys
2, 2
HART 5 Fast Keys
2, 2, 5
HART 7 Fast Keys
2, 2, 5
To Next Page
Loading...
