38
Reference Manual
00809-0100-4021, Rev GC
Section 3: HART commissioning
April 2014
HART® commissioning
3.4.3 Device dashboard Fast Key sequences
Fast key sequences are listed below for common 3144P transmitter functions.
Note
The fast key sequences assume that “Device Revision Dev 5 (HART 5) or v6 (HART 7), DD v1” is
being used. Table 3-1 provides alphabetical function lists for all Field Communicator tasks as
well as their corresponding fast key sequences.
Table 3-1. Fast Key Sequences
Function HART 5 Fast Keys HART 7 Fast Keys
2-wire Offset Sensor 1 2, 2, 1, 5 2, 2, 1, 6
2-wire Offset Sensor 2
2, 2, 2, 5 2, 2, 2, 6
Alarm Values
2, 2, 5, 6 2, 2, 5, 6
Analog Calibration
3, 4, 5 3, 4, 5
Analog Output
2, 2, 5 2, 2, 5
Average Temperature Setup
2, 2, 3, 3 2, 2, 3, 3
Burst Mode
N/A
2, 2, 8, 4
Comm Status
N/A
1, 2
Configure additional messages
N/A
2, 2, 8, 4, 7
Configure Hot Backup
2, 2, 4, 1, 3
2, 2, 4, 1, 3
Date
2, 2, 7, 1, 2
2, 2, 7, 1, 3
Descriptor
2, 2, 7, 1, 3
2, 2, 7, 1, 4
Device Information
2, 2, 7, 1
2, 2, 7, 1
Differential Temperature Setup
2, 2, 3, 1
2, 2, 3, 1
Filter 50/60 Hz
2, 2, 7, 5, 1
2, 2, 7, 5, 1
Find Device
N/A
3, 4, 6, 2
First Good Temperature Setup
2, 2, 3, 2
2, 2, 3, 2
Hardware Revision
1, 8, 2, 3
1, 11, 2, 3
HART Lock
N/A
2, 2, 9, 2
Intermittent Sensor Detect
2, 2, 7, 5, 2
2, 2, 7, 5, 2
Lock Status
N/A
1, 11, 3, 7
Long Tag
N/A
2, 2, 7, 2
Loop Test
3, 5, 1 3, 5, 1
LRV (Lower Range Value)
2, 2, 5, 5, 3 2, 2, 5, 5, 3
Message
2, 2, 7, 1, 4 2, 2, 7, 1, 5
Open Sensor Holdoff
2, 2, 7, 4 2, 2, 7, 4
Percent Range
2, 2, 5, 4
2, 2, 5, 4